PROJECT
ITEM #
QUANTITY
DATE
APPROVAL
The Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.com
Delfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A.
RFFSC
Built-in self-contained milk & ice cream dispensers
Short form specifications
The exterior sides and top edge shall be 20-gauge galvanized steel.
Exterior bottom to be 14-gauge galvanized steel.
Interior shall have (2) separate compartments, one refrigerated and one
freezer. Inner liners shall be water-tight and constructed of 22-gauge
stainless steel with a 1.25" (3.2cm) I.P.S. drain. Openings shall have
throat liners constructed of high impact plastic. Unit to be insulated
with foamed-in-place polyurethane insulation with a non-conductive top
breaker strip.
Each opening shall have an insulated, stainless steel folding lid with
high impact plastic liner, molded rubber edge and black plastic handles.
(1) stainless steel louver shall be provided for installation in the cabinet
to allow proper air flow to the condensing unit.
Each self-leveling mechanism shall be field adjustable by adding or
removing stainless steel extension springs in the elevator housing inside
the unit. The elevators shall be connected by removable platform carriers
constructed of 18-gauge stainless steel.
(6) anodized aluminum divider trays will be supplied per opening.
NOTE: See chart on back for ice cream storage capacity.
Refrigeration system shall use HFC-404A refrigerant. Refrigerant flow
shall be controlled by an (2) expansion valves. Cabinet shall maintain
36°F to 40°F (2°C to 4°C) temperature in the refrigerator section and
0°F to 5°F (–18°C to –15°C) temperature in the freezer section with lids
closed for storage.
Refrigerator section shall be controlled by an EPR valve; the freezer
section shall be controlled by a pressure control. Controls shall be
located near the condensing unit.
Electrical connections shall be 115 volt, 60 cycle, single phase. Unit
shall have a 9' (2.7m) long electrical cord and NEMA 5-15P installed at
the mechanical end.
Optional accessories & modifications
• Lid locking device
• Wire baskets
• Lexan
®
lids (refrigerated compartment only)
• Inclusion of this option will alter the electrical specifications of the
unit. Special voltages (contact factory)
This equipment is intended for storage and/or
display of pre-packaged or bottled products only.
Model RFFSC-103
