Checking the elevon trim
Make sure that the outboard elevons are leveled with the inboard elevons (the inboard elevons are fixed).
The accuracy should be less than 1 mm.
WARNING –
When handling the rover, make sure that the elevons can move freely and are not
obstructed in any way. Impaired movement of the elevons can cause the servo motor to burn up.
Checking the elevon response
Tap the
Move/Stop elevon
button in the Aerial Imaging software and watch the elevons on the rover.
Make sure the elevons move fluently and in unison.
WARNING –
When handling the rover, make sure that the elevons can move freely and are not
obstructed in any way. Impaired movement of the elevons can cause the servo motor to burn up.
When the elevon response is checked, the
button is enabled.
Assembling the launcher
1. Unfold the launch slide.
CAUTION –
Take care when unfolding the launch slide as there are sharp edges that can cause
finger cuts.
2. Secure each section of the launch slide by lifting the appropriate handle and hooking it into the next
section of the launch slide. Close the handles.
75
Delair-Tech
|
676, Rue Max Planck – 31670 Toulouse-Labège, France
|
Tel: +33 (0) 5 82 95 44 06
|
Capital: 238 110,30 € - APE: 3030Z – Intra-Community VAT number: FR90 53 09 69 781 – 530 969 781 R.C.S. Toulouse
This document is the sole property of Delair-Tech and cannot be used or reproduced without the written authorization of Delair-Tech
.
