Installation Manual
Festoon Systems for I-Beams
Program 0314
MAL0300-0001-EN
www.conductix.com
translated document
page 49 of 56
10
Dismantling and disposal
10.1
Safety
WARNING!
Danger of injury due to improper disassembly!
Stored energy, sharp components, points, and edges on and in the festoon system or the tools
needed can cause injury.
Therefore:
- Make sure there is sufficient space before starting work
- Handle open, sharp-edged components with care.
- Make sure the workplace is tidy and clean! Loosely stacked or scattered components and tools
can cause accidents
- Dismount components properly. Be aware of the high dead weight of some components. If
necessary, use lifting gear.
- Secure components so they cannot fall or topple
- Involve the manufacturer in case of any unclear points.
WARNING!
Danger of injury from moving components!
Incautious handling of the festoon system can lead to severe injury or damage to the festoon
system.
Therefore:
- Be sure that the festoon system does not start by itself.
- While it is moving, do not reach into moving parts, particularly the interface between the buffer and
buffer plate.
- Block off the dangerous area under the system.
CAUTION!
Danger of tripping on projecting parts!
When working on the festoon system, there is a risk of tripping.
Therefore:
- When walking in the work and danger area, be careful of projections and depressions in the floor.
No loose objects may be left on the floor.
WARNING!
Danger of crushing!
When moving the festoon system, there is a danger of crushing limbs between the buffer and buffer
plate, as well as between the carriage and the track carrier.
Therefore:
- Do not enter the danger area of the cable-festoon system when the system is moving
