proxSafe flexx
20
ps_flexx_wi_en
V08/09/09
For operation without
proxSafe Terminal!
3.7
Operating the flexx without proxSafe terminal
If you intend to operate your flexx system without a proxSafe terminal, it is mandatory to set
the jumper J1 on the flexx backplane (jumper closed, as shown in the picture below).
Otherwise there will be no power supply for the backplane!
picture 3.7.1: jumper setting for J1 if operated without proxSafe terminal
Important:
If there are more backplanes connected to each other in one line (due to more
flexx housings within one installation), the jumper J1 of at least one backplane
within the line has to be set (i.e. closed).
