INFO
You can only select previously configured curves that are
compatible
with the
Sensor output (x-axis)
units
and range. If necessary, change the sensor output before selecting the curve.
INFO
You can also select a
pre-configured curve
, for example
VDO 10
. This type of curve cannot be modified.
2. Do not modify the curve.
CAUTION
Modifying the curve affects ALL sensor inputs that are using the same curve.
3. If required, create sensor failure alarms.
4. Select
Save
.
INFO
Remember to
Write
when you have finished editing the input/output configuration.
7.7.6 Configure the output setup
AI
AO
PWM
DI
DO
Configurable for:
●
●
INFO
The function previously selected determines the x-axis for the output setup.
Configure output setup overview
1. Select the analogue output function on the
Function
page.
2. On the
Output setup
page, configure a new curve for the sensor, or select a previously configured curve.
CAUTION
Configure the
minimum
and
maximum
range for each axis BEFORE creating the curve.
3.
Write
the output configuration to the controller.
Output setup: New curve
1. Select
Rename
to change the curve name.
•
PPM 300 PICUS manual 4189341080 UK
www.deif.com
Page 99 of 213
