Degometal GO 3313, Manual

Page: 17 / 32

17
www.degometal.com
1. GO 3313 : PRESENTATION
Use for intended purpose
The blind rivet nut setting tool must only be used for the purpose of setting blind rivet nuts as described
in these operating instructions. Observe the safety information!
Safety information
CAUTION
!
The following safety rules must be observed to ensure adequate protection against electric
shock, injuries or fire hazards.
●
The blind rivet nut setting tool is intended solely for the purpose of processing blind rivet nuts.
●
Never overload the blind rivet nut setting tool; work within the specified working
capacity.
●
Never use the blind rivet nut setting tool in a humid or wet environment
or close to flammable liquids
or gases. Danger of explosion!
●
Ensure that the battery is properly secured in the handle.
●
Always remove the battery when the blind rivet nut
setting tool is not in use and for maintenance.
●
Never use the blind rivet nut setting tool as a hammer.
●
When not in use, keep the blind rivet nut setting tool in a dry, closed room and out of the reach of
children.
●
Always wear protective goggles when working with the blind rivet nut
setting tool. Personal protective
equipment such as protective clothing, gloves, safety helmet, non-slip
footwear,
ear protection and fall
arresting device is recommended.
●
The air inlets for the motor must not be obstructed; do not insert any objects into them.
●
When setting down the blind rivet nut setting tool, make sure that
itcannot fall.
●
Use only genuine spare parts for repair.
●
Repairs must be carried out only by skilled personnel. In case of doubt,
always
send in the blind rivet
nut setting tool to the manufacturer.
●
Do not use the tool without material! The blind rivet nut could be flung
from the blind rivet nut setting
tool! Never turn the blind rivet nut setting tool
towards yourself or towards other
persons
!
Working range
Sets blind rivet nuts up to M10.
Alu,
Steel
,
Stainless St
.
Equipment / Accessories
Nosepieces: M6 in
working
position
M4, M5, M8, M10 in accessory magazine
Wrench: Hexagon
screwdriver
WAF 4
Hanger: Concealed in housing
Battery charger: 230 V, 50 Hz
Quick-charge battery: 60 or 90 minutes
FR
ANCA
IS
EN
GLI
SH