5 Homedepot.ca
Please contact 1-866-308-3976 for further assistance.
Installation
1
Determining the mounting
location
NOTE:
The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground.
□
Determine the mounting location – wall mount
only.
□
Position the lamp heads (A) in the general
direction of the desired light coverage.
Wall Mount
2
Removing the mounting plate
NOTE:
This fixture comes with a mounting plate (D). It is
pre-assembled on the light fixture (B) for shipping.
□
Unscrew the two decorative screws (CC)
connecting the light fixture (B) to the mounting
plate (D) and remove the mounting plate (D)
using the pull loop.
3
Installing the mounting bracket
WARNING:
Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
NOTE:
Four mounting bracket screws of various sizes are
included. The installation will only require two. Discard the
unused mounting bracket screws after installation.
□
Remove the existing light fixture.
□
Install the mounting bracket (FF) using the
mounting bracket screws (AA or BB) that best
fit the junction box.
□
Firmly pull on the mounting bracket (FF) to
verify it is securely mounted to the junction
box. If necessary, use the screws that were
removed from the existing light fixture.
A
CC
D
B
AA or BB
FF
C
