DEEP SEA ELECTRONICS
DSE335 INSTALLATION NSTRUCTIONS
053-136
ISSUE 3
ACCESSING THE FRONT PANEL EDITOR (FPE)
•
Press and hold the
(stop) and the
(tick) button.
•
If a module security PIN has been set, the PIN number request is shown.
•
Press
(tick). The first ‘#’ changes to ‘0’. Press
(up) or
(down)
to adjust it to the correct value.
•
Press
(right) when the first digit is correctly entered. The digit you
have just entered shows ‘#’ for security.
•
Enter the remaining digits of the PIN number. Press
(left) to move
back to adjust one of the previous digits.
•
Press
(tick) after entering the final PIN digit. The PIN is checked for
validity. If the number is not correct, you must re-enter the PIN.
•
If the PIN has been successfully entered (or the module PIN has not been
enabled), the editor is displayed.
EDITING A PARAMETER
•
Press the Press the
(left) or
(right) buttons to cycle to the section
you wish to view/change.
•
Press the
(up) or
(down) buttons to select the next parameter or
previous parameter within the current page.
•
When viewing the parameter to be changed, press the
(tick) button.
The value begins to flash.
•
When editing the scheduler, press the
(left) or
(right) button to
move between the various parameters of the scheduler.
•
Press the
(up) or
(down) buttons to adjust the value to the required
setting.
•
Press the
(tick) button to the save the current value, the value ceases
flashing.
•
Press and hold the
(tick) button to save all changes and exit the editor.
•
Alternatively, press and hold the
(stop) button to cancel all changes
and exit the editor.
TYPICAL WIRING DIAGRAM
