2/ INSTALLING THE HOOD
EN
- During installation, or in the case of repairs, the appliance must be unplugged.
- Make sure that the electrical tension of the power source corresponds to the electrical tension
indicated on the information plate on the inside of the hood.
-If you need to modify the electrical layout of your house in order to be able to use the hood,
call a qualified technician.
- If you use the hood in the discharge mode, never hook up the appliance to a discharge conduit used
for combustion fumes (boilers, chimneys, etc.) or a CMV unit (Controlled Mechanical Ventilation).
- The discharge conduit, whatever it may be, must never exit into the attic.
- Install the hood at a safe distance of at least 70 cm from the hob surface, whether they are
electric, gas, or mixed.
If you have a conduit exit to the outside:
fig. 2
The hood can be hooked up to the opening by way of a discharge conduit (minimum diameter
F125mm, unpainted, in aluminium, flexible, or in non-flammable material). If the conduit has
a diameter of less than 125 mm, you must use the hood in the recirculation mode.
If you do not have a conduit exit to the outside:
fig. 1
All of our appliances can operate in the recirculation mode.
In this case, you must add an active carbon filter that acts to control smells.
ELECTRIAL HOOK UP
This appliance conforms to the European Directives 2006/95/EC (Low Voltage Directive)
and 2004/108/EC (Electromagnetic Compatibility).
When you install the appliance and carry out maintenance, it must be unplugged from the power
source or the fuses must be disengaged or removed. Electrical hook up must be carried out
before the appliance is installed in the cabinet.
Check that:
- the power source is sufficient,
- power cords are in good condition,
- The diameter of the cables conforms to installation regulations.
- MOUNTING THE HOOD
Installation must conform to the regulations in force regarding the ventilation of
enclosed environments. In France, these regulations are container in the DTU 61.1 of the
CSTB. In particular, discharged air must not be channelled into a conduit used for exhaust
discharge or discharge from devices that operate with gas or other combustible materials.
The use of unused conduits is not permissible without the approval of a qualified tech
-
nician. The minimum distance between the hob surface and the lowest part of the hood
must be 70 cm. IF the instructions for the cooker installed under the hood require an even
greater distance, this must take precedence.
- INSTALLATION
Before installing the hood, remove the anti-grease filters to avoid damaging the appliance. To
remove the anti-grease filters, push the handle toward the lower part of the hood and rotate the
filter downward, removing it from its housing (Fig. 3A).
Attention: Installation must be carried out by at least two people.
Before installing the hood, ensure a supply of electricity to the conduit and the discharge hole,
in the case of an installation with discharge.
34
Summary of Contents for DHD585XE1
Page 2: ...2 ...