1. Make the connections on the master box.
Tab.6
1
Domestic hot water circulation loop pump
2
DHW booster pump
3
Domestic hot water temperature sensor, high position
4
Domestic hot water temperature sensor, low position
5
Flow temperature sensor after mixing valve
6
Pump for heating circuit with mixing valve
7
Three-way mixing valve
8
"Room Unit" programmable room thermostat
9
Safety thermostat with manual reset, for underfloor heating
10
Flow temperature sensor after mixing valve
11
Pump for heating circuit with mixing valve
12
Three-way mixing valve
13
Sensor for swimming pool circuit
14
Swimming pool pump
15
Automatically regulated electronic pump for direct heating circuit
16
Outdoor temperature sensor
17
Sensor for buffer tank or cascade flow
99
Bridging
2. Make the S-BUS connection to the generator.
6.2.2
System configuration
For this hydraulic configuration, certain parameters must be adapted.
1. Select the Cascade
Producer Manager Algicon.
2. Select Enable master func.
3. Select Yes.
4. Select the Cascade
Producer Manager Algicon.
5. Check the following parameters:
Tab.7
Code
Description
Adjustment required
NP006
Cascade Type
Traditional
NP009
CascInterStageTime
4
NP011
CascadeTypeAlgo
Temperature
6. Press the key.
7. Select Installation Setup.
Fig.10
2
1
12
7
14
3
17
4
13 10
5
MW-1001113-2
99
6
11
9
15
16
8
99
99
99
14
13
15
16
17
12
11
10
9
8
6
7
5
1
2
3
4
CIRCA
CIRCB
CIRCC
On
6 Connecting diagrams and configuration
18
7703592 - v02 - 14062018
