Dedicated Micros ©2007
18
Anal
ogue t
o IP Enc
oder
Serial
This page allows configuration of the Serial port on the rear of the unit. It can be programmed to
operate with telemetry.
Serial Port Usage
The unit supports a number of RS485 serial protocols. This
option allows one of these to be selected from the list. When
used as a DM dome IP Power Supply, the Dennard protocol
must be selected..
Telemetry Protocol
The Encoder will accept either Dennard or DM-Serial
protocols
Baud Rate, Parity, Data Bits This allows the communication settings to be configured.
Stop Bits, Flow Control
Cancel
Settings are automatically saved when the page is closed.
Use this button to cancel any changes before navigating away
from the page.
Note:
When a telemetry protocol is selected these settings will be set to the default to pre-
determined values for the protocol, and should not normally be altered manually.
Note:
Any changes to this page will require the unit to be reset. Use the reset button on the
Network Page.
Note:
The telemetry receiver in the dome should be set to address number 1. Dennard domes
should have the blue selector set to 0 and the yellow selector to 1
6.6
