DECKED.COM
|
#DECKEDUSA
|
@DECKEDUSA
TBFDL | v.1 |
Page 1
@DECKEDUSA | #DECKEDUSA
FOLLOW US:
LADDER INSTALLATION
TOOLS NEEDED:
• 5/32” hex wrench
• Rest the folded ladder on a table or hard surface so that you can read the instructions on the bottom of the first rung.
• While holding the top rung, pull the bottom rung from the ladder assembly until both the bottom and middle rungs lock in place.
• Set the ladder on the ground vertically next to the passenger side of your Tool Box.
• Raise both arms and extend them up and over the edge of the Tool Box to meet with the mounting discs.
NOTE: The ladder brackets must be facing down.
• Using a 5/32” hex wrench, install the hardware in the order shown, DETAIL A. Repeat on opposite side. Tighten until snug -
DO NOT OVERTIGHTEN.
• Return the ladder to the Tool Box by collapsing the rungs and folding back into place.
➡
CAB
A
DETAIL A
LADDER
BRACKET
“CLICK”
STEP 1
▼
WARNING DON’T DO THIS
▼
“CLICK” AGAIN
STEP 2
STEP 3
USING THE LADDER:
WATCH LADDER INSTRUCTIONAL VIDEOS:
DECKED.COM/LADDER
PLACE LADDER ON SOLID GROUND
WITH BOTH RUNGS LOCKED INTO
PLACE (LADDER STEPS 1-3). FAILURE
TO DO THIS COULD ALLOW LADDER
TO SWING INTO TRUCK AND CAUSE
DAMAGE TO THE VEHICLE
POSITION LADDER
VERTICALLY TO
SOLID GROUND
