DDC DRC-11525, Hardware & Software Manual, Page: 15 / 85

HARDWARE INSTALLATION
Card Installation
The SB-3622X card is a PCI Target device and may be inserted into any PCI
2.1, or higher, compatible slot. The card is designed for a +5V PCI slot, and
will not operate in a +3.3V PCI slot. When installing the card, the following
should be observed:
NEVER insert or remove the card with the power turned on.
ALWAYS take proper precautions to guard against static damage. Use a
wrist strap if available, or ensure proper static grounding by touching the
power supply cover
WITH POWER OFF .
Insert the card at a slight angle so that the connectors first protrude from the
rear opening and then gently press the card into the motherboard connector.
Secure with proper hardware.
Make sure that adjacent cabling and wiring do not hinder the airflow around
the card.
This card is designed as a Plug-and-Play device and as such, there are no
jumpers or switches to be set for address and interrupt selection.
Figure 1
shows a block diagram for the Digital-to-Synchro/Resolver PCI Card.
Data Device Corporation SB-3622X Manual 2