DCS Paganini Upsampler, User Manual, Page: 6 / 29

dCS Paganini Upsampler
User Manual Software Issue 1.1x
March 2011
Filename: Paganini Upsampler Manual v1_1x.docx
Page 6
English version
S
TEP
-
BY
-S
TEP
G
UIDE
This section guides you through setting up the unit for basic operation.
Preliminaries
The Menu / Setup Guide sheet details the menu structure and details the two most common set-ups.
For digital interfaces, use with cables designed for digital audio:
•
for AES/EBU interfaces use 110
Ω
screened, twisted pair cables fitted with one male XLR
connector and one female XLR connector.
•
for Word Clock interfaces, use 75
Ω
coax cables fitted with BNC plugs.
•
for SPDIF RCA interfaces, use 75
Ω
coax cables fitted with RCA Phono plugs.
•
for IEEE 1394 interfaces, use the IEEE 1394 cable provided with the unit.
•
For USB interfaces, use the USB cable provided with the unit.
Connect the power cable supplied to the power inlet on the Upsampler’s rear panel, plug the other end
into a convenient power outlet.
!
Please do not use an excessively heavy or inflexible power cable as this may damage the
power inlet connector.
Set the rear panel power switch to the
I
position. Briefly press the
Power
button and wait about 30
seconds while the Upsampler configures itself. The display will show in sequence:
dCS
,
Paganini
Upsampler
and
No Input > 24/96
.
If the unit is likely to be set in an unfamiliar state, you can reset it as follows:
Press the
Menu
button, press the
→
(
Output
) button once, then the
Menu
button again to display the
Upsampler Settings menu. Press the
←
(
Input
) button repeatedly to highlight the Factory Reset menu
page. Press the
Menu
button and wait a few seconds while the settings are reset.