DBI SALA Exofit, User Instructions

Page: 8 / 68

8
Step 5. Replace the pads before using the harness. See Figure I. To replace the
ExoFit XP Pads, lay out the harness as shown and place the pads under
the straps. Then wrap the zippered fl aps (18) over the straps and close
the snaps and zippers. Note: The lower snap closure on the leg strap pad
must connect between the layers of the seat strap (19). Only one leg pad is
shown for clarity.
Step 6. The retrieval harness pads have openings for the shoulder D-rings. See
Figure J. When replacing the pads, make sure the D-rings are located on
the shoulder straps so that they protrude through the openings (20) and
are available (21) for connecting retrieval systems.
B. WASHING INSTRUCTIONS ARC FLASH FULL BODY HARNESS:
Step 1. Spot clean the ExoFit full body harness. Lay the webbing on a fl at surface
and clean each side using a mild bleach-free detergent with a sponge or
light brush, so as not to damage or bulk up the fi laments. Rinse thoroughly.
Water temperature for wash and rinse must be cool or cold.
IMPORTANT: ASTM F887-2004 rated harnesses should use a mild bleach-free
detergent rather than soap; as soap may leave a residue which could affect fl ame
resistance.
Step 2. To thoroughly clean the ExoFit XP, remove the pads. See Figure H. Undo
the snaps and zippers (16). The pads will fall away from the harness straps.
Only one leg pad is shown for clarity (17).
Step 3. Harness and pads should be thoroughly air dried before using. Do not dry
in a mechanical dryer.
IMPORTANT: A wet harness will have reduced strength.
Step 4. See step 5 above.
Step 5. See step 6 above.
IMPORTANT: An excessive buildup of dirt, paint, etc. may prevent the full body
harness from working properly, and in severe cases degrade the webbing to a point
where it weakens and should be removed from service.
More information on cleaning is available from Capital Safety. If you have questions
concerning the condition of your harness, or have any doubt about putting it into
service contact Capital Safety.
MATERIALS
Standards: All harnesses marked with ASTM F887-2004 meet all testing requirements
of the standard.
Webbing:
Standard Harness: 26.6 kN (6,000 lb.) tensile strength Polyester
Arch Flash Harness: 31 kN (7,000 lb.) tensile strength Nylon; 31 kN (7,000 lb)
tensile strength Nomex® covered Kevlar®
Pad and Label Cover: All outer fabric is Nomex® and Kevlar® blend. Hook and loop
fasteners are fi re resistant.
Optional Accessories:
• Hip pad with side D-rings
• Nomex® covered Kevlar® webbing
• Non-sparking/Non-conductive PVC coated hardware
• Arc-rated hip, leg, and back pads
• Polyurethane coated, arc-rated dorsal web loop
Note: Nomex® and Kevlar® are owned by DuPont