© Copyright 2007, DB Industries, Inc.
User InstrUctIon ManUal
rebar lanyards for Work PosItIonIng
This manual is intended to meet the Manufacturer’s Instructions as recommended by OSHA and
should be used as part of an employee training program.
Figure 1 - Rebar Lanyards for Work Positioning
WarnIng:
This product is part of a work positioning system. These instructions must be provided to the user
and the rescuer (see section 8 Termonology). The user must read and understand these instructions before
using this equipment. The user must follow the manufacturer’s instructions for each component of the system.
Manufacturer’s instructions must be followed for proper use and maintenance of this equipment. Alterations or
misuse of this equipment, or failure to follow instructions, may result in serious injury or death.
IMPortant:
If you have questions on the use, care, or suitability of this equipment for your application,
contact DBI‑SALA.
IMPortant:
Before using this equipment, record the product identification information from the ID label into
the inspection and maintenance log in section 9.0 of this manual.
Instructions for the following series products:
Rebar Lanyards for Work Positioning
(See back page for specific model numbers.)
Lanyard Legs
Labels
Lanyard Legs
Leg Connector:
Snap Hooks
Connect to
Harness or Belt
Center Connector:
Snap Hook or
Carabiner
Connects to Anchor
Leg Connector:
Snap Hooks
Connect to
Harness or Belt
Center Connector:
Snap Hook
Connects to Anchor
Labels
