29
LVX XM15
Cod. 420120241 REV.1.0
POWER SUPPLY CONNECTION
•
Connect the audio input (4) properly, selecting the source with the “Input sensitivity” selector (3). Set
selector to “LINE” if the input signal is coming from a line input or a mixer output, or to “MIC” for a
microphone input (use a dynamic microphone). Please see the table below for a quick overview of
audio cables.
•
To connect the power supply, connect the cable with the POWERCON connector to “MAINS INPUT” (8)
•
The Signal/ON LED (2) will blink briefly at power-up
•
Turn the Audio Input Sensitivity encoder (3) to adjust system gain to the appropriate level.
•
When you have connected the audio source properly and switched it on, raise the volume gradually to
ensure that the speaker is producing sound
POWER SUPPLY
•
Set the DSP preset to the desired value:
1.
FLAT - Equalisation without emphasis in a particular frequency range
2.
WEDGE - Equalisation with emphasis for live monitoring purposes
W1 - VOCAL, convenient for voice (speech and vocals)
W2 - HF PASS (80 Hz), for use with filtering of the frequency band from 80 Hz and higher
W3 - HF PASS (120 Hz), for use with filtering of the frequency band from 120 Hz and higher
3.
SERVICE - Enables firmware update (see section FIRMWARE UPDATES)
4.
ON STAND - Equalisation with emphasis for pole mount application (tripod stand)
S1 - LOUDNESS, helps with background noise
S2 - HF BOOST, boosts low frequencies
S3 - HF REDUCTION, reduces high frequencies