Raider Max 175 (single-seat, double-seat): Service Manual EEC Version:2.0 April 2005
34
6. Thick Water Hose
3.8.2 Specifications
Pipe Diameter
22mm
Body Mark
BS26-1245
Fuel Level
18.5+/-1.0mm
Air Adjusting Screw
1 3/4
Main Jet
100
Low Speed Jet
# 35
Idle Speed
1500+/-100rpm
3.8.3
Points for Attention
a)
No smoke or fires in the working places.
b)
Assemble the O-rings correctly and replace with new ones.
c)
Drain out the fuel in the float chamber before disassembly.
d)
Don’t disassemble the automatic choke by yourself.
3.8.4 Inspection of Automatic Fuel Cup
No smokes or fires!
a)
Stop the engine and pull the fuel tube from the carburetor;
b)
Check if the fuel flows out;
The fuel cup is normal if the fuel stops flowing after all the
remaining fuel in the fuel cup and tube (5-10cc) has been
drained out;
If the fuel continues to flow out, the negative pressure tube
is clogged.
c)
Pull the negative pressure tube from the air intake pipe and
suck with mouth to produce negative pressure on the vacuum
film;
If when the vacuum film produces negative pressure, the fuel
flows out of the fuel tube, and when the negative pressure
stops, the fuel stops flowing, then the automatic fuel cup is
normal.
d) If the fuel doesn’t flow out when the negative pressure is
applied, please follow the following steps:
1.Clear the negative pressure tube if it is clogged;
2.Blow the film from the air intake pipe of the automatic fuel cup.
3.8.5
Automatic Side Circuit Starter
a) Check the automatic side circuit starter;
Check the conduction of all the automatic side circuit starter wires;
Replace the automatic choke if the resistance value exceeds the standard value.
Resistance value: below 10
Ω
(10 min after the engine stops)
