3. Use
3.1. Intended use
DazeBox, for indoor and outdoor applications, is suitable for recharging in commercial or private parking of
Plug-in electric and hybrid vehicles. The charging station is designed to be installed on a wall or column.
DazeBox has been designed, built, tested and documented in accordance with current regulations and
safety standards.
The instructions in this manual must be followed carefully. Otherwise dangerous situations could arise. In
addition to these instructions, the general safety regulations for risk prevention must be followed.
This device must be grounded. In the event of damage, grounding reduces the risk of electric shock.
The illustrations and explanations in this manual refer to a typical version of the device. The version to
which this manual is linked may be slightly different.
In normal operating conditions (once installed and connected to the network), DazeBox is in stand-by,
awaiting charging. The status of the LEDs is pulsed green.
To charge the vehicle, pull out the charging cable by always holding it by the plug and never by the cable
itself and connect it to the vehicle socket. The status of the LEDs will turn into a green and blue, as it is
being verified.
Once the machine is connected and accepts the cable, the vehicle is charging and the status of the LEDs
will turn to pulsed blue.
The charging cycle ends by disconnecting the charging cable. Other details are described in the manual
provided by the vehicle manufacturer. At the end, the plug must be placed neatly in the connector holder in
the center of the DazeBox.
3.2. Unintended use
It is to be considered unintended use any condition of use in which one or more of the conditions expressed
in "Intended use" are not observed.
Daze Technology srl does not assume any responsibility for damage to persons or things deriving from
unintended use of the machine.
Do not try to open the device manually.
Do not charge any other electric instruments except for electric and plug-in hybrid cars.
8
ENG - June 2020 - Rev. 1