4
5. Next, locate the two 2-way Pre-Wired Crossover Boards. Cut the small white connector off of the red and black
wires and strip the wires back roughly 1/2".
6. Once the glue is dry you can install a crossover board into each speaker cavity using four #6 x 3/4" Deep Thread
Pan Head Screws Black. We recommend placing them in the center of the bottom panel inside each left/right
enclosure. Ensure that each foam-wrapped speaker wire lead can reach the holes in the baffle. The red (+) and
black (-) wires go to the woofer, the blue (+) and black (-) wires go to the tweeter. The crossovers can be secured
with the included wood screws. BE CAREFUL NOT TO OVERTIGHTEN SCREWS.
7. Remove the 4-conductor Speaker Wire Harness from the amplifier package (#1 in the amplifier wiring diagram)
and feed the two +/- conductors into each speaker chamber through the small holes in the internal walls. Leave
enough slack in the center cavity to be able to plug the harness into the amplifier, roughly 8-10".
8. Using the wiring diagram below, solder the left and right channels of the wire harness to each crossover
observing polarity. Use heat shrink to cover the soldered connections.
