INSTALLING TH€ TURBO 601 - MACINTOSH llw, Him,
ORLAA 6 0 0
3
Preparing the Macintosh for installation
DayStar designed the installation o f the Turbo 601 to be easy. You must,
however, take certain precautions:
1. Back up all hard drives before beginning the installation.
2. Check your hard drives with Apple’
s Disk First Aid.
3. Update your hard drives’
driver software with a version known to be
compatible with the Power Mac. If you are using Apple HD SC Setup, update
your drives using version 7.3.2 or greater. If you used a non-Apple formatter,
contact the vendor to make sure your version is PowerPC compatible.
4. Turn off the Mac and remove the pow er cord and all accessory cables.
3. Press the pow er switch on the rear o f the Macintosh three times to drain
the pow er supply.
6. Place the Macintosh on an unobstructed flat work area with the rear o f the
Macintosh facing you.
Installing the Turbo 601
1. Open the Macintosh (This procedure is detailed in the Apple Getting
Started reference guide).
2. Put on the anti-static wrist strap following the instructions on the package.
3. Locate the accelerator slot and remove any card that may be installed there.
Accelerator Slot
NuBus Slots
View of the inside of the Macintosh Ilvi, IIvx, Performa 600
21
