1 GETTING S1M T€D
Quick installation reference
Please read all o f the instructions before you start the installation procedure. If
you are not experienced in the installation o f the Turbo 601, w e suggest that
you follow the detailed instructions in the following chapters. If you are familiar
with installing the Turbo 601, you may follow these steps:
1. Back up all hard drives.
2. Check your hard drives with Apple’
s Disk First Aid.
3. Update your hard drives’
driver software with a version known to be com
patible with the Power Macs. If you are using Apple HD SC Setup, update
your drives using version 7.3.2 or greater. If you used a non-Apple format
ter, contact the vendor to make sure your version is PowerPC compatible.
4. Turn off the Macintosh and remove all connectors and the pow er cord.
5. Remove the Mac cover.
6. Put on the anti-static wrist strap following the instructions on the package.
7. Remove any add-in cards from the motherboard cache/accelerator slot.
8. Orient the Turbo 601 over the motherboard cache/accelerator slot and
press dow n until it is firmly seated.
9. Replace the cover and attach the pow er cord and other remaining cables.
10. Update your system software to a universal “system for all Macintoshes”
version and then run the DayStar installer.
11. Restart the Mac - If any problems occur, see Troubleshooting, Chapter 3.
Removing the Turbo 601
If you must remove the Turbo 601, follow the instructions below:
1. Turn off the Macintosh and remove all connectors and the pow er cord.
2. Remove the Mac cover.
3. Remove the Turbo 601 from the motherboard cache/Accelerator slot.
4. Replace the cover and make sure all cables are properly connected.
This concludes removal of the Turbo 601.
12
