Make sure the used gas type is the same with the one stated in the
brand plate.
Turn on the gas and power supply of the water heater . The light will
highlight on the
,
and
buttons existing on the control
panel with a warning sound. If you turn on the tap without turning on
the power supply, your device will not operate and give an audio
warning.
By pressing the
On/Off button on the control panel, see that the
lcd display is operating. By pressing the
Tepm+ and
Temp-
buttons set the water temperature you want between 35
o
C and 65
o
C
degrees. The water temperature you set will show stability after
some time according to the distance of the water heater to the tap
and the change of the water pressure.
Turn on the water valve. A sign will appear which shows the fan is
turning on the Lcd display with the douche ejector sign. After that
the fan which is inside will operate. After a few seconds the device
will start to operate and hot water will be ready for instantly use. In
the meantime the flame sign will occur on the lcd display. In case the
device does not operate, try these procedures again several times.
Contact the authorized service if the device does not operate.
5. USING OF THE WATER HEATER
5.1. THE Operation Of The Heater
Summary of Contents for UKDAX-11ST
Page 1: ......
