DigaStudio Installation Notes
Page 9 of 15
By clicking on the relevant tab the page for those settings is displayed and the settings can then be
modified.
4.1.1 Channels 1..4
These tabs allow a number of channel-specific settings to be performed:
•
Source - choice of required input source
•
Equalizer - filter parameter settings
•
Channel on/off
•
Channel Mode - selection of the mono/stereo parameters depending on source selected
•
Insert configuration
•
Output routing - not yet supported
•
Limiter - not yet supported
•
Panorama/balance setting
•
Gain setting
The COPY/PASTE EQ buttons allow the current EQ settings to be quickly copied to other channels:
4.1.2 Sensitivity
The input sensitivity for each analog source can be set here.
4.1.3 I/O Settings
A number of parameters can be set here, for example:
•
48V phantom supply and low-pass filter for the microphone channels
•
Sync mode for the AES/EBU output
•
Selection of the talkback microphone
•
Source selection for the playback channels as well as playback parameters
4.1.4 Limiters
This section allows limiter parameters to be set. The assignment of the limiters can either by to the
input channels or to the sums. A mixed-mode is not possible.
4.1.5 Key assignments
This page allows the assignment of the channel 2 and 3 input-selection matrix keys to any required
source.