DigaStudio Installation Notes
Page 7 of 15
3
Beginning of Operation
3.1 DigaStudio
Switch on the DigaStudio Box by means of the power switch on the front panel. Box and Desk will then
perform a short initialization sequence (about 5 seconds) and when completed the last operational
configuration is automatically loaded. The DigaStudio can now use all the DigaStudio Desk supported
functions independently of the PC.
3.2 PC software
1. First start the interface driver DSINTERFACE.EXE if this has not already been done via
the Autostart folder. The respective icon should be visible in the system tray.
2. Start the actual application DIGASTUDIO.EXE.
In the upper left corner the DigaStudio Man-
ager appears.
3. Clicking on the middle button brings up the DigaStudio Configuration Manager (DigaStudio Pa-
rameter Setup screen). Here you can configure all necessary settings.
2
Note: depending on when the software was delivered it is possible that some functions are not available (e.g.
TimeStamps etc.). Updates will be available at a later date. Information about the latest software releases is
available in our ISDN mailbox and on our internet homepage http://www/david-gmbh.de.