(1)
Attach the spokeshave blade to the
D
og
-B
one
with the brass nuts
(A)
.
Place this assembly
in a bevel-up position
on the sharpening
block with the bevel
just overhanging the
edge
(B).
(2)
Next position the honing guide on the
D
og
-B
one
but do not tighten it into place.
(3)
To establish the bevel angle, place a straight
edge on the bevel so it fully contacts the bevel
surface, then slide the honing guide wheel to
contact the straight edge
(C–D)
.
Once this bevel angle is determined, lock the device
down. The assembly is now ready to use
(E)
.
(4)
For future reference,
mark the location of
the sharpening guide
on the
D
og
-B
one
.
One could either place
a strip of tape on the
D
og
-B
one
and mark
the tape, or scratch
this reference into
the surface. Note that
after many uses, the
reference marks may
need re-calibration
(F)
.
(5)
If a secondary
bevel is desired,
reposition the
sharpening guide
towards the edge
by 3/8" or invert
the assembly and
use the straight
edge to visualize
the secondary
bevel
(G–H)
.
ncworkshops.com
•
[email protected] PO BOX 980
•
North Conway, NH
•
03860
ncworkshops.com
•
[email protected] PO BOX 980
•
North Conway, NH
•
03860
S H A R P E N I N G
BLOCKS STONES
&
A
B
C
D
E
F
G
H
W I T H
