2: Installation
2-4
PRC1099A-MSOP
Installing the
Antenna
1. Remove the cover from the antenna mount (
refer to Front Panel Layout
figure on page 3-1
).
2. Screw the antenna support into the antenna mount.
3. Extend the antenna by holding the base (the heaviest section) and
carefully whipping it outward. If all sections are not secure, insert the
sections by hand.
4. Secure the extended antenna into the support.
5. Periodically tighten the antenna in the mount.
Caution:
Make sure the base is tight against the mount. Even a small
gap between the base and the mount can cause the antenna to break
leaving the thread portion in the mount. In addition, the end of the
mount activates an internal switch that activates the automatic antenna
tuner. The plastic filling in the thread is designed to prevent the antenna
from unscrewing. If the plastic wears, the antenna can unscrew under
vibration.
Figure 2-2. Manpack Harness Installation
Shoulder straps
Transceiver
Retaining
Straps
Shoulder
Strap
Buckle (2)
Shoulder strap ring (2)
Cotton Duck
Bag
Lower
Strap (2)
Metal Braces
Belt Strap (2)
Retaining Strap
Buckles (2)
