Datex-Ohmeda S/5 M-P, Technical Reference Manual Slot

Page: 4 / 42

Datex-Ohmeda S/5 monitors
Document No. 8001013-1
ii
6.1 Spare parts list.......................................................................................................................................28
6.1.1 Pressure Module, M-P, Rev. 00.......................................................................................................28
6.1.2 Pressure Module, M-P, Rev. 01.......................................................................................................29
6.1.3 Pressure Module, M-P, Rev. 02.......................................................................................................29
6.1.4 Pressure Module, M-P, Rev. 03.......................................................................................................29
6.1.5 Pressure Module, M-P, Rev. 04.......................................................................................................29
6.1.6 Pressure Temp Module, M-PT, Rev. 00 ............................................................................................30
6.1.7 Pressure Temp Module, M-PT, Rev. 01 ............................................................................................31
6.1.8 Pressure Temp Module, M-PT, Rev. 02 ............................................................................................31
6.1.9 Front panel stickers for AS/3 modules (square buttons)...................................................................31
6.1.10 Front panel stickers for S/5 modules (round buttons) ..................................................................31
7 Earlier Revisions 33
APPENDIX A
35
Service check form A-1
TABLE OF FIGURES
Figure 1 Datex-Ohmeda M-PT and M-P Module...................................................................................................1
Figure 2 Front panel of M-P and M-PT Module.....................................................................................................5
Figure 3 PT board block diagram ........................................................................................................................6
Figure 4 Pressure transducer principle of operation.............................................................................................7
Figure 5 Temperature measurement principle.....................................................................................................8
Figure 6 Serial communication and opto isolation section...................................................................................8
Figure 7 Module bus connector (X1) .................................................................................................................10
Figure 8 Troubleshooting flowchart...................................................................................................................23