Datex-Ohmeda F-LM1, Technical Reference Manual

Page: 43 / 377

Service check
6.2.2 Recorder test
10. Open the paper compartment cover. Check that the message “Recorder: Cover open”
appears on the screen, then close the cover.
11. Select Main Menu - Record/Print- Record Wave
and check that the recorder starts recording. Select Stop Wave to stop recording.
Check that the quality of the recordings is acceptable.
"
6.2.3 PCMCIA card test
12. Insert the Memory card labeled “Data” in the DataCard slot. Check that the message “Data
Card inserted” appears in the message field and the white data card symbol in the upper
right hand corner of the screen appears within one minute.
"
6.2.4 Network test
13. Connect the Mon-Net cable and the Identification plug to the monitor.
14. Check that the monitor connects to the Datex-Ohmeda Network, i.e. the network symbol
is displayed on the upper right-hand corner of the screen.
A message regarding the connection to Datex-Ohmeda Information Center should appear in
the message field on the screen.
15. Press the
Menu
button to enter the Network service menu:
Monitor Setup - Install/Service (Password 16-4-34) -
Service View (Password 26-23-8) - Monitor - Communication
Check that:
− the “location ID number” matches with the ID plug connected to X3
−
the packets and bytes IN is increasing slowly
− the packets and bytes OUT is increasing quickly.
−
the “connections” shows the names of the connected networks
− the counters for data errors (“CRC”, “Frame”, “Transm.”) are stable
NOTE: The counters may show values greater than 0. However, any values increasing
continuously indicate a problem.
16. Check that the counters for hardware errors (“Intern.”, “Missed”, “FIFO”, “Overrun”) all show
0. If any of the counters show a value greater than 0, it indicates a problem on the CPU
board.
Return to the
Monitor Setup menu by selecting Previous Menu repeatedly.
"
Document No. M1051339
35