Datex-Ohmeda F-LM1, Technical Reference Manual

Page: 122 / 377

Datex-Ohmeda S/5 Light Monitor
1.3.3 Feature connector, X3
The connector provides module bus output with reset, two analog outputs, defib sync output and
Nurse Call -signal with floating relay contact.
Pin out of the high density D15 male connector (front view)
Feature connector pin assignments
Pin I/O Signal
1)
Signal
2)
Description Signal levels
1 - N/C N/C - -
2 I/O RS485+ RS485+ RS-485 data (AM module bus) RS-485
3 O DSYNC DSYNC Defib synchronization output CMOS, active high, I out max 2.5 mA
4 O P5VD +5V +5V output
3)
5 O ANOUT2 ANOUT2 Analog output, ch 2 -5 V .. +5 V
6 I/O RS485- RS485- RS-485 data (AM module bus) RS-485
7 GNCOEQ GND signal ground -
8 O NCALL NCALL Nurse Call CMOS, active high, I out max 2.5 mA
9 GNCOEQ GND signal ground
10 O ANOUT3 ANOUT3 Analog output, ch 3 -5 V .. +5 V
11 - N/C N/C - -
12 O 485RST# 485RST# RS-485 module reset CMOS, active low
13 - N/C N/C - -
14 O RLYOPEN RLYOPEN NCALL relay,
normally open contact
4)
15 O RLYCOM RLYCOM NCALL relay, common contact
4)
1)
Actual signal name
2)
Signal name seen by user
3)
I
max
= 200 mA
4)
Relay contacts are potential free. I
max
= 0.5 A, U
max
= 100 VAC/VDC.
Document No. 8000060-1
6