26
7. DVIP Control Protocol
7.1 DVIP Setup
The DVIP is a user interface that allows the user to control multiple PTC-200 cameras remotely.
The DVIP setup procedure is outlined as follows:
1.
Locate the DIP switch at the bottom of the PTC-200 camera
.
2.
Set DIP Switch positions 1 and 4 to ON
.
3.
Plug in the power cord into the PTC-200 and connect it to a monitor via the HDMI interface.
4.
Open the main menu by pressing the menu button on the remote control and select option
4 “
Remote Control
.
”
[MAIN MENU]
1: CAMERA SET (NORMAL)
2: MEMORY
3: VIDEO OUTPUT
4:
REMOTE CONTROL
5: SYSTEM
6: CAMERA SET (ADVANCE)
7: RESET P/T/Z
8: ESCAPE
5.
Se
lect “
SET DVIP
” to configure the DVIP port
.
[REMOTE CONTROL]
1: PAN/TILT REVERSE: P+T
2: REMOTE SOURCE: DVIP, SW
3: SET RS422
4:
SET DVIP
5: SET IR
6: PTZ INFO. OUTPUT: OFF
7: ESCAPE
