Datavideo KMU-100, Instruction Manual

Page: 12 / 88

12
3. Connection to the KMU-100 – DV Link
A platform that unites all!
The DV Link platform is a very simple and useful software developed for configuration,
diagnostics and control of multiple devices (for example four KMU-100 converters)
communicating through a common DVIP protocol.
A camera operator or operators can easily change the functions of each of the visible
devices or a group by triggering the pre-defined presets, without the need to use the main
KMU-100 management application. DV Link application thus allows quick reconfiguration of
the equipment for a specific task.
The DV Link platform connects multiple devices to control them on a single application.
We invite all the
KMU-100 users to download the DV Link application for free.
The technical specifications, manual and the download link can be found on the product
page.
3.1 Hardware Connection
Prior to the use of the KMU-100, you must first set up the hardware system and configure
the IP settings between the PC and the KMU-100. The subsections below will guide you
through the connection process step by step.
1. First of all, connect the DC 12V power to the KMU-100 device.
2. Turn ON the power switch to enter the device into standby mode.
3. Connect the PC to the KMU-100 device via an Ethernet cable.
4. Lightly touch the power switch button on the front panel for 2-3 seconds to switch ON the
KMU-100 device.
5. The default IP address of the KMU-100 device is 192.168.1.10.
6. The PC IP address and the subnet mask are respectively configured to 192.168.1.5 and
255.255.255.0.
DC IN
Power Switch
Ethernet Port