Datavideo iCast 10NDI, Instruction Manual

Page: 21 / 96

21
Chapter 4 OSD Menu
The OSD menu allows the user to access certain device
settings such as the network settings, the program output
frame rate, the program layout, and channel settings. You
will be able to reset the device to its factory defaults and
enable various program CGs. Furthermore, the stream and
record status, firmware version, and disk capacity can be
viewed on the OSD menu.
As you turn on the power switch located at the rear of the iCast 10NDI, the following device
information will be displayed on the 2” LCD screen after the device boots up.
iCast 10NDI IP: 192.168.001.053
Storage Capacity: 00000 MB Remaining
PGM Stream: 1080p59/12MB/RTMPS
PGM Layout: Quad View
Multiview: 1/2/3/4
Tap the menu browsing knob up to view the record status or down to view the stream status such as
the disk capacity and the encoder that each video channel is assigned to.
Record Status Stream Status
Main CH 1 CH 2 CH 3 CH 4 CH 5 PGM
Sub CH 1 CH 2 CH 3 CH 4 CH 5 PGM
Main CH 1 CH 2 CH 3 CH 4 CH 5 PGM
Sub CH 1 CH 2 CH 3 CH 4 CH 5 PGM
Storage: 00000 MB Remaining Storage: 00000 MB Remaining
To access the OSD menu, simply tap the menu browsing knob right. The OSD menu is summarized in
the table below.
Main Menu Level 1 Level 2 Level 3
System Network Settings DHCP Disable
Enable
Static IP
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
FW & FPGA Version FW Version
FPGA Version
Factory Default
Storage Settings Format Type FAT 32
NTFS
exFAT
Storage Capacity
Program CG Text ON/OFF
Graphic ON/OFF
2” LCD
Screen
REC