Datavideo iCast 10NDI, Instruction Manual

Page: 17 / 96

17
2.3 Disk Assembly
Instructions to assemble a 2.5” SSD/HDD in a disk enclosure will be detailed in this section.
1. Lift the cover of the disk enclosure.
2. Reassemble the disk enclosure after placing the
SSD/HDD in the enclosure tray. Insert the screws
into the holes found on the two sides as shown in
the diagram on the left. Fasten the screws to
secure the SSD/HDD to the enclosure tray.
3. The 2.5” SSD/HDD assembled in the disk
enclosure is shown in the diagram on the left.
4. Insert the assembled disk enclosure into the disk
slot on the front panel then slide the
LOCK/UNLOCK switch to the LOCK position. The
LED indicator will illuminate as soon as the disk is
inserted.