Installation Guide
Packing List - Check Contents Prior To Installation:
1) 1 - 5.25" Plastic 68pin Frame
2) 1 - 3.5" Plastic 68pin Tray
3) 1 - Screw/Key Pack
3) 1 - Installation Guide
Electrostatic Discharge
Many components on your hard disk are susceptible to electrostatic
discharge. To prevent damage to these components, take careful
precautions before handling your hard disk.
Remove the Casing for your Tower/Enclosure
1. Unplug the computer, as well as all peripheral devices and cables.
2. Referring to the owner's manual for your computer or enclosure,
remove the outer casing.
3. Referring to the owner's manual for your computer or enclosure,
remove any front panel or bezel on the 5.25" bay you plan on installing
your tray & frame in.
Install the Frame
1. Place the Frame into the 5.25" Bay with the backplane of the Frame
toward the rear of the bay. To determine which side of your frame is
the top, view the frame from the back (Figure 2) if the fan is on the
left side, you are holding the frame right side up.
2. Line up the four bracket holes in the frame with the corresponding
holes in your 5.25" bay. Using the screws which can be found inside
of your tray (along with the keys to the tray lock), fasten the frame
into the bay.
3. With the frame securly fastened, slide the tray into the
frame to ensure that the tray fits snugly but smoothly
into the frame. Be sure that the tray is right side up by
viewing the front (handle side) of the tray. If the tray is
right side up, the lock will be visible on the right side of
the tray. As the tray is slid into the frame, apply even
pressure to both sides of the tray to ensure a proper
connection.
4. Remove the tray by gently lifting on the FORCE-LESS
TM
handle until the tray is dislodged from the frame. Then,
gently pull on the tray with the handle until the tray is
completely removed from the frame assembly.
Make Wire Connections Between Frame and Enclosure
1. With the frame mounted in the enclosure, turn the
enclosure so that you have a clear view of the
backplane of the frame. Connect the 68 pin HDD
controller cable and the power cable.
SCSI III 68pin Removable Tray & Frame, Plastic
Figure 1
Top
Bottom
Figure 2
2. Referring to Figure 3, as well as the documentation
provided with your enclosure, connect the SCSI ID
cables to the five connectors as shown in Figure 3.
Installation Guide - DataTrans 68 pin Plastic Removable Tray&Frame, Rev 1.0 - July 1998 - P/N DT51UWS-P
(MORE)
Figure 3
68 pin HDD
Controller
Power
Connector
8 Signal
8 Signal
8 Signal
8 Signal
8 Signal
4 Signal
4 Signal
4 Signal
4 Signal
4 Signal
2 Signal
2 Signal
2 Signal
2 Signal
2 Signal
1 Signal
1 Signal
1 Signal
1 Signal
1 Signal
Ground
Ground
Ground
Ground
Ground
