Packing List - Check Contents Prior To
Installation:
1) 1 - HD 68 pin Hot Plug Tray
2) 1 - 1.6” Tray Cover Grill
3) 1 - 1.0” Tray Cover Grill
4) 1 - Screw Pack
Electrostatic Discharge
Many components on your hard disk are susceptible
to electrostatic discharge. To prevent damage to these
components, take careful precautions before handling
your hard disk.
Compatibility Disclaimer
NOTE: This Hot Plug tray is only compatible with the
following models of Compaq
®
Proliant
TM
:
3000, 1600, 6000, 6500, 7000, 5500, 1600R,
1850R, 2500, 6200H, 1200, 850R
NOTE: Drives used with this Hot Plug tray should
be verified as compatible with one of the above
server models prior to attempting installation.
Drive Termination Warning
NOTE: You MUST disable any automatic or
passive drive termination features on your hard
drive prior to using a drive in this tray.
Remove Cover Grill from Tray
1. This kit comes with two cover grills for the tray,
a 1” Low Profile cover, and a 1.6” Full Height
cover. Remove whichever of these two
covers is attached to the tray by sliding the
cover back and then lifting it up and away from
the tray.
Install Drive into Tray
1. Make sure your drive is oriented correctly on
the tray so that the HD 68 pin connector side
of the drive is pointed toward the Rear of the
Tray. (Figure 2).
2. Fasten the drive to the bottom of the tray via
the four mounting holes (Figure 2).
Installation Guide
Compaq
®
Proliant
TM
Ultra2 / SCSI III 68pin Hot Plug Tray
(MORE)
Figure 2
Installation Guide - Hot Plug Tray, HD 68pin, Compaq Proliant , Rev 1.0 - March 1999 - P/N CQPTUWS
Compaq
®
and Proliant
TM
are both Trade Marks of Compaq Computer Corporation.
Figure 1
HD 68 Pin I/O
Connector
SCSI ID &
LED Block
Drive Power
Connector
Tray
Cover
Slots
(Both
Sides)
Drive Mount
Holes
Tray
Release Levers
Power, Activity,
and Error LED’s
Rear of Tray
(Connector)
