AP25 Installation and Operating Guide
Page 95
AP25 Installation & Operating Guide
Document # 9301H79500 Ver. 1.00
4.4 Network
Menu (System) > Network
Figure 74. Network Screen
The Network screen displays the current network mode and IP address. It also displays whether
or not the network connection is currently up or down. Use it to change between dynamic and
static IP addressing.
In static IP mode, you can enter values for the IP address, Netmask, and Gateway.
To change or enter a value, touch the white box under the appropriate label.
The DNS Server, NTP server and log file server can be entered whether using DHCP or
Static modes.
Speed may be set to Auto, 10Mb/s only or 100Mb/s only
4.4.1 SNMP
Menu (System) > Network > SNMP
Figure 75. SNMP Setup Screen
Agent Mode:
If set to disabled, the SNMP is turned off. When enabled the SNMP the agent
mode may be set to v1 (SNMPv1) or v2 (SNMPv2) to match the SNMP server requirement.
Manager IP Address:
Set this to the IP address to send SNMP trap messages.
roCommunity
: This is the access code for SNMP read messages.
rwCommunity
: This is the access code for SNMP write messages.
