AP25 Installation and Operating Guide
Page 58
AP25 Installation & Operating Guide
Document # 9301H79500 Ver. 1.00
4.2.4 Access Control
Menu (System) > Access Control
Figure 30. Access Control Screen
By creating passwords, you can control user access to certain functions of the AP25.
The
Netcmd password
is the password used to control access to operator-level commands from
a remote network device (i.e. automation device, server) or theater management system.
A
Setup password
will restrict users from access to the
System Setup
menu. A user without the
correct password will not be able to make any changes to the system, formats, network, or
automation. This password will not block access to the Home Screen items, but will block access
to the “menu” button
The setup password needs to be entered only once when entering the setup menus and remains in
effect until:
The AP25 is powered cycled
One hour passes with no activity
The ReLock Setup button is pushed.
If the password is lost and you cannot access the AP25, contact Datasat Digital Entertainment
technical support.
Password restrictions take place as soon as the password is configured in the Access Control
screen.
Passwords are case sensitive. You can enter upper case characters by using the shift button on
the virtual keyboard displayed on the LCD. To remove password protection, clear the password
by pressing the Clear button, then enter a hyphen “-“ and press “OK”.
Note: When removing password protection, if no hyphen is entered (blank selection), the
AP25 will continue to ask for a password to enter the setup menus. In that case select the OK
button to enter the setup menus without entering a password.
Note: When logging into an AP25 using a VNC device, the default password is “-“. If a
password has been set for the AP25, this password will be needed for VNC log in.
