AP25 Installation and Operating Guide
Page 54
AP25 Installation & Operating Guide
Document # 9301H79500 Ver. 1.00
4.
Finally, hold down the current format button (shown in green, Non Sync in this example)
for about 5 seconds, until
Fmt Fdr
(in yellow) matches the fader setting (6.5 in our
example).
Figure 26. Setting Fader Level for a Format (3 of 3)
The
Non Sync
audio format button is now set at 6.5 and will remain so until changed.
Note
: If you adjust the fader up/down for a selected format but do not do step 4 above (to
change the Fmt Fdr assignment), then when you leave and return to this format, it will assume
the previously set Fmt Fdr setting.
4.2.2 Updating AP25 Software
There are two ways you can update your software.
Use an internet connection to connect to the servers at Datasat Digital Entertainment to select
and install the update.
Update from a USB Device.
Both methods are described in more detail below.
Fmt Fader
now
shows a
level of
6.5
