120 20131-301
Gemini G3 - User Manual
21
4.7 IP Settings
4.7.1 Unit Status
Displays values that identify the unit and show its basic operating condition.
4.7.1.1
Unit Status
Figure 12- Unit Identification and Status
Item
Description
Displays GeminiG3 software revision information retrieved from the connected unit.
Have this information handy if contacting Dataradio support.
The Banner fields are deciphered as following:
GeminiG3:
Product name
EDBA (Enhanced Dynamic
Bandwidth Allocation)
Protocol Name
Multiband
Band(s) of operation
Banner
PROD
V2.7
R07_R0712181200
Production build
Vx.y Major.minor version number
Rxx_R… Sequential Package Release Timestamp
Station Name
Displays name of the connected unit.
Configured under Setup Basic
Î
General
Î
Station Name
System ID
Displays System’s unique identification number
Configured under Setup Basic
Î
General
Î
System ID
Local Time
Displays time of configured time zone computed using UTC time and configured Time
Zone (If SNTP is enabled)
Position (GPS)
Global position in Longitude (East-West) and Latitude (North-South) displayed using
information obtained from a GeminiG3 decoding a valid GPS input signal.
If no previous position was obtained, display shows (Unknown).
Positions are reported in degrees plus decimal minutes.
E.g. : Longitude of 73 degrees, 39 minutes and 45 seconds West would appear as:
073 39.7500 W
Status
Displays “Initializing” at startup, “Registered” in normal operation and “Roaming”
while attempting to register to another base station.
Unit Status
Normally displays “Ok” in the message area.
Displays various warnings or messages in the event of hardware failure,
If indications persist, have the status information handy if contacting Dataradio sup-
port.
Acknowledge Unit Status
Press this button to clear the Unit Status message area.