DI–710 Series and DI-715B Series Hardware Manual
Accessories
42
The DI-705
The DI-705 can be used with DI-710 “D” models (see “37-pin D sub connector” on page 23) and with DI-715B
instruments.
Using the DI-705 with DI-710 “D” Models
The DI-705 plugs into the 37-pin D sub connector of the front panel of DI-710 “D” models and provides convenient
screw terminal access to analog inputs, analog outputs, and the Digital I/O.
Note: The digital I/O is not available in
stand-alone mode.
The screw terminals accept 16-22 gauge wire and each is silk-screened with the corresponding
“D” connector pin number (see “37-pin D sub connector” on page 23). The DI-705 also features a 37-pin male “pass-
through” connector, which allows you to connect our BNC cable (model number CABL-4), or our 5B back plane
cable (model number CABLE-1), or any 37-pin DAS-16 compatible cable to the DI-710 while still allowing screw
terminal access.
Any combination of single-ended or differential channels may be connected to the DI-705, but keep in mind a differ-
ential channel uses two analog inputs. Configure single-ended and differential channels on the DI-705 the same way
as on the DI-710. See “Instrument Front Panel” on page 22 for more information.