iboot-poe-p_v190422w
iBoot-PoE-P
Page 29
12. Troubleshooting
The iBoot-PoE-P has a recessed pushbutton switch in the event the unit is not performing as expected.
Use the pushbutton as follows:
Action
Result
Momentary
Soft Reset. Will not change output status.
5 Seconds push
Reset to Factory Defaults. Hold the button in
until the Outlet LED is blinking, then release.
Hold in while and
Power up the iBoot
Recovery Mode. Allows upload of new
firmware to the current IP Address. Will
recover to the Factory default IP Address
192.168.1.254 if the database has been
corrupted.
Factory reset
– excluding basic network settings can be done
using the Device Management Utility (DMU). See Section 3.2.
