Single Slot Dock Ethernet Module
NOTE
Read this manual carefully before performing any type of connection from the
terminal to a host PC using the Single Slot Dock Ethernet Module.
The user is responsible for any damages caused by incorrect use of the
equipment or by inobservance of the indication supplied in this manual.
NOTE
Do not attempt to disassemble the Single Slot Dock Ethernet Module, as it
does not contain parts that can be repaired by the user. Any tampering will
invalidate the warranty.
The Single Slot Dock Ethernet Module is a snap-on module for Single Slot Docks which, paired
with a Datalogic mobile computer, builds a reading system for the collection, decoding and
transmission of barcoded data.
The Single Slot Dock Ethernet Module is an Ethernet communication adapter between the host
computer and an Ethernet network.
Figure 1 – Single Slot Dock Ethernet Module General View
Key:
A)
Module selection LED
B) Snaps
C)
Contacts for connection to Single Slot Dock
D)
Ethernet port with integrated Link and Speed LEDs
E)
Ethernet/USB selection switch
822000950
INSTALLATION
CAUTION
Installation of the Ethernet Module should always be made with power OFF!
To install the Ethernet Module:
1.
remove the label covering the communication module connector on the bottom of the
Single Slot Dock, as shown in the figure below:
2.
plug the Ethernet Module into the Single Slot Dock until the snaps clicks, as shown in the
figure below:
Figure 2 – Single Slot Dock Ethernet Module Installation
A
B
C
E
D
