Reading Parameters
26
RIDA™ DBT6400
Reading Parameters
Point the reader at the target and press the Scan button
to enable the aiming system and the illuminator (red
beam) to decode the barcode label. The aiming system will
briefly switch off during the acquisition time and, if no
code is decoded, it will switch on again before the next
acquisition. The illuminator will remain on until the sym-
bol is decoded.
As you read code symbols, adjust the distance at which
you are holding the reader.
Aiming System
A number of options for customizing control of the Aiming
System are available. See the PRG for more information
and programming bar codes.
Good Read Green Spot Duration
Successful reading can be signaled by a good read green
spot.
Use the bar codes below to specify the duration of the
good read pointer beam after a good read.
GOOD READ GREEN SPOT DURATION
ENTER/EXIT PROGRAMMING MODE
Green Spot Duration = Disable (Green Spot is Off)
Green Spot Duration = Short (300 msec)
