Datalogic Rhino II A6, User Manual

Page: 31 / 78

Rhino II Configuration
User’s Manual 25
Screen Blanking
You may need to blank the screen when your vehicle is in motion, a
requirement in some countries. You can do it by applying a positive
voltage to a designated COM port pin. You must use an external
sensor that will either provide a positive voltage or close a relay
when the vehicle moves.
If you use a relay, the positive voltage from pin 9 of the selected
COM port should be wired as input to the relay. The output from the
sensor or relay should be wired to pin 1 (DCD) or pin 6 (DSR) of the
selected COM port. The screen blanking cable from Datalogic (p/n
94ACC0157) is wired to pin 9 (pink) and pin 6 (grey).
Configuration
Key - Section name Parameter – Info
[General]
ScreenBlankBits
Setting the bit to 0 will disable screen blanking on the
corresponding pin.
15 = default.
Bit 1 (1): COM1:DCD
Bit 2 (2): COM1:DSR
Bit 3 (4): COM2:DCD
Bit 4 (8): COM2:DSR