Programming
14
QuickScan™ QBT2400
The reader is factory-configured with a set of standard
default features. After scanning the interface bar code from
the Interfaces section, select other options and customize
your reader through use of the programming bar codes avail-
able in the Product Reference Guide (PRG) or Datalogic Alad-
din™ configuration software (both available on the Datalogic
website).
Using Programming Bar Codes
This manual contains bar codes which allow you to reconfig-
ure your reader. Some programming bar code labels require
only the scan of that single label to enact the change.
Other bar codes require the reader to be placed in Program-
ming Mode prior to scanning them. Scan an ENTER/EXIT bar
code once to enter Programming Mode; scan the desired
parameter settings; scan the ENTER/EXIT bar code again to
accept your changes, which exits Programming Mode and
returns the reader to normal operation.
Configure Other Settings
Additional programming bar codes are available to allow for
customizing programming features, if your installation
requires different programming than the standard factory
default settings. Reference the PRG or Datalogic Aladdin™
configuration software.
Resetting Standard Product Defaults
Reference the PRG for a listing of standard factory settings. If
you aren’t sure what programming options are in your reader,
or you’ve changed some options and want the factory set-
tings restored, scan the bar code below to copy the factory
configuration for the currently active interface to the current
configuration.
NOTE
Factory defaults are based on the interface
type. Configure the reader for the correct inter-
face before scanning this label.
Standard Product Default Settings
