Datalogic QuickScan Lite 21 Series, Product Reference Manual

Page: 256 / 324

References
246
QuickScan
TM
Lite QW2100
Scan Mode
Selects the scan operating mode for the reader. Selections are:
Trigger Single—
When the trigger is pulled, scanning is activated until one of the following
occurs:
- Scanning Active Time has elapsed
- a label has been read
- the trigger is released
This mode is associated with typical handheld reader operation: when the trigger is pulled, scan-
ning starts and the product scans until the trigger is released, or a label is read, or the maximum
Scanning Active Time has elapsed.
Trigger Hold Multiple —
When the trigger is pulled, scanning starts and the product scans
until the trigger is released or Scanning Active Time has elapsed. Reading a label does not dis-
able scanning. Double Read Timeout prevents undesired multiple reads of the same label
while in this mode.
Trigger Pulse Multiple—
When the trigger is pulled, continuous scanning is activated until
Scanning Active Time has elapsed or the trigger has been released and pulled again. Double
Read Timeout prevents undesired multiple reads of the same label while in this mode.
Flashing—
The reader flashes
1
on and off regardless of the trigger status. Flash rate is con-
trolled by Flash On Time and Flash Off Time . When Flash is ON the reader reads continu-
ously. When Flash is OFF scanning is deactivated.
Always On—
No trigger pull is required to read a bar code. Scanning is continually on. Dou-
ble Read Timeout prevents undesired multiple reads while in this mode.
Stand Mode—
No trigger pull is required to read a bar code. Scanning is turned on automati-
cally when an item is placed in reader’s field of view. If the trigger is pulled, the reader acts as if it
in single read mode.
Double Read Timeout prevents undesired multiple reads of the same
label while in this mode.
Trigger Object Sense—
This mode is similar to Stand Mode, except that a trigger pull is
required to activate the decoder.
1. Controlled by
Flash On Time
.