Selecting the Interface Type
QUICK REFERENCE GUIDE
7
SELECTING THE INTERFACE TYPE
Upon completing the physical connection between the
reader and its host, proceed directly to Interface Selection
below for information and programming for the interface
type supported by the reader and scan the appropriate
bar code to select your system’s correct interface type,
according to your application.
For interfaces other than those listed in this manual, see
the Quickscan™ I QD2200 Product Reference Guide (PRG),
available online at
.
Interface Selection
The reader will support all the following host interfaces:
•
USB HID POS
•
USB Toshiba TEC
•
USB (Keyboard, COM, OEM)
•
USB Composite (Ke COM)
•
USB for Magellan Scanners
Information and programming options for each interface
type are provided in this section. For defaults and addi
-
tional information associated with each interface, proceed
to the corresponding chapter in the Quickscan™ I QD2200
PRG.
CONFIGURING THE INTERFACE
Scan the appropriate programming bar code to select the
interface type for your system.
NOTE: Unlike some other programming features
and options, interface selections require that you
scan only one programming bar code label. DO
NOT scan an ENTER/EXIT bar code prior to scan
-
ning an interface selection bar code.
Some interfaces require the scanner to start in
the disabled state when powered up. If additional
scanner configuration is desired while in this
state, pull the trigger and hold for 5 seconds. The
scanner will change to a state that allows pro
-
gramming with bar codes.
