SETUP
40
POWERSCAN™ PD/PM/PBT9600
Configuring Other Features
If your installation requires different programming than the standard factory default
settings, the following sections of this manual allow configuration of non-interface-spe
-
cific settings you might require:
Configuration Using Bar Codes:
General Features includes programming for scanning,
beeper and LED indicators and other such universal settings.
Reading Parameters:
Reading Parameters include programming for scanning, beeper
and LED indicators and other universal settings.
1D Symbologies:
Includes options concerning the bar code label types (symbologies).
These settings allow you to enable/disable symbologies, set label lengths, require check
digit, etc.
Software Version Transmission
The software version of the device (reader or base station) can be transmitted over the
RS-232, Keyboard and USB interfaces by scanning the following labels.
Transmit Software Version (reader)
Transmit Software Version (base station)
Resetting the Product Configuration to Defaults
Restore Custom Default Configuration
If you aren't sure what programming options are in your reader, or you've changed
some options and want to restore the Custom Default Configuration that may have
been saved in the reader, scan the Restore Custom Default Configuration bar code
below. This will restore the custom configuration for the currently active interface.
Restore Custom Default Configuration
NOTE: Custom defaults are based on the interface type. Configure the
reader for the correct interface before scanning this label.
