DISABLE ALL SYMBOLOGIES
ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
131
DISABLE ALL SYMBOLOGIES
Scan this label to disable all symbologies.
1D GLOBAL FEATURE
Default settings are indicated at each feature/option with a star. Also reference
for a listing of the most widely used set of standard fac
-
tory settings. That section also provides space to record any custom settings needed or
implemented for your system.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING bar code at the top of applicable program
-
ming pages.
2. Scan the correct bar code to set the desired programming feature or parameter.
You may need to cover unused bar codes on the page, and possibly the facing
page, to ensure that the reader reads only the bar code you intend to scan.
3. If additional input parameters are needed, go to
, and scan the
appropriate characters from the keypad.
Complete the programming sequence by scanning the ENTER/EXIT PROGRAMMING bar
code to exit Programming Mode.
$AD
Disable All Symbologies
NOTE: Additional information about many features can be found in the
“References” chapter.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
